DTF Transfers - ND (Next Working Day - FOR REAL)

Font smaller than 12pt and fine lines thinner than 1/16" are not recommended!
 

Turnaround Service Cutoff Times:
If received after the cutoff time, the orders will be delayed an extra day.

SAME DAY SERVICE: MUST be received before 12:00 PM ET on a working day to be ready the SAME DAY.

Next Day Service - For Real: MUST be received before (Any Time Today, on a working day) until (23:55) - 11:55 PM ET, on a working day to be ready the NEXT WORKING DAY.

2 Working Days Service - For Real: MUST be received before (Any Time Today, on a working day) until (23:55) - 11:55 PM ET, on a working day to be ready the 2nd WORKING DAY, 2 Days later.

3 Working Days Service - For Real: MUST be received before (Any Time Today, on a working day) until (23:55) - 11:55 PM ET, on a working day to be ready the 3rd WORKING DAY, 3 Days later.

If received after the cutoff times, the orders will be delayed an extra day.

DTF Transfers - Recommendations

Pre-heat the garment for about 3-5 seconds to remove excess moisture and iron the fabric. Then depending on DTF Material peel:

Cold Peel

Temperature to be set to:
310 - 325 Degrees - For Cotton
295 - 315 Degrees - For Cotton/Polyester
265 - 285 Degrees - For Polyester

Heat Press Time - First Press:
10-15 Seconds for the first press

Peel Type:
Cold peel -  After pressing, let cool for 1-2 minutes then peel.

Heat Press Time - Second Press - After Peeling: We recommend pressing a second time for 3-5 seconds with a teflon sheet, parchment paper or any other similar type sheet.

HOT Peel

Temperature to be set to:
280 - 310 Degrees - For Cotton
280 - 300 Degrees - For Cotton/Polyester
260 - 280 Degrees - For Polyester

Heat Press Time - First Press:
12 Seconds for the first press

Peel Type:
HOT peel -  After pressing, Peel INSTANTLY. Do not wait. If item cools and/or does not peel, reheat a few seconds.

Heat Press Time - Second Press - After Peeling: We recommend pressing a second time for 3-5 seconds with a teflon sheet, parchment paper or any other similar type sheet.

These are recommendations only. Temperature and Press time may vary based on  Heat Press and materials.